You would need to state the purpose of the report. You could explain why you are evaluating specific issues and how this would benefit your client company.
2024-11-21 14:13:07
BPP Business School Coursework Cover Sheet
Please use this document as the cover sheet of for the 1st page of your assessment. Please complete the below table – the grey columns
Module Name
|
Business Project
|
Programme Name
|
|
Student Reference Number
(SRN)
|
|
Assessment Title
|
|
Please complete the yellow sections in the below declaration :
By submitting this coursework you agree to all rules and regulations of BPP regarding assessments and awards for programmes.
Please note that by submitting this assessment you are declaring that you are fit to sit this assessment.
BPP University reserves the right to use all submitted work for educational purposes and may request that work be published for a wider audience.
MSc Management
Business Project
Summative Assessment Brief
1. General Assessment Guidance
- Your summative assessment for this module is made up of this 5000 words submission which accounts for 100% of the marks
- You are required to submit all elements of your assessment via Turnitin online access. Only submissions made via the specified mode will be accepted and hard copies or any other digital form of submissions (like via email or pen drive etc.) will not be accepted.
- For coursework, the submission word limit is 5000 words. You must comply with the word count guidelines. You may submit LESS than 5000 words but not more. Word Count guidelines can be found on your programme home page and the coursework submission page.
- Do not put your name or contact details anywhere on your submission. You should only put your student registration number (SRN) which will ensure your submission is recognised in the marking process.
- A total of 100 marks are available for this module assessment, and you are required to achieve minimum 50% to pass this module.
- You are required to use only Harvard Referencing System in your submission. Any content which is already published by other author(s) and is not referenced will be considered as a case of plagiarism.
· Please note late submissions will not be marked.
You can find further information on Harvard Referencing in the online library on the VLE. You can use the following link to access this information: http://bpp.libguides.com/Home/StudySupport
- BPP University has a strict policy regarding authenticity of assessments. In proven instances of plagiarism or collusion, severe punishment will be imposed on offenders. You are advised to read the rules and regulations regarding plagiarism and collusion in the GARs and MOPP which are available on VLE in the Academic registry section.
- You should include a completed copy of the Assignment Cover sheet. Any submission without this completed Assignment Cover sheet may be considered invalid and not marked.
2. Assessment Brief
Introduction
This business project assessment will require a 5000-word consultancy report on your chosen company. Your chosen company is your client who has asked you to provide the consultancy report.
The report should cover the following key areas:
- Introduction
- Challenges / problems the client is facing: Identified issues with how this is connected to the
current affairs. Plus, an examination of the problem from the consultant’s perspectives
- Purpose of the report
- Stakeholder analysis – need to analyse how current issues are impacting on stakeholders.
- Evaluation and analysis with secondary data
- Recommendations / solutions to the problem.
You are required to show your understanding of the importance of strategy in business. You will also need to discuss how your project would impact stakeholders and provide relevant recommendations or solutions which could be of value to your chosen organisation.
Business Consultancy Report Structure
The following structure reflects a common way of organising final business reports. You are advised to follow this structure, but you can adapt it to reflect the exact nature and details of your project in liaison with in-class supervisors.
- PP Declaration Page
- Title page
- Table of contents
- List of figures/tables/abbreviations – if required
- Executive summary
- Introduction
- Challenges / problems the client is facing: Identified issues with how this is connected to the
current affairs. Plus, an examination of the problem from the consultant’s perspectives
- Purpose of the report
- Stakeholder analysis – need to analyse how current issues are impacting on stakeholders.
- Evaluation and analysis with secondary data
- Recommendations / solutions to the problem.
- Harvard references
- Appendices (if required)
The whole report should be 5,000 words. The front cover, table of contents, bibliography, and appendices are not included in this limit
Word Count Breakdown
Your total word count for the business project is 5000 words. It is important that you ensure you cover each section thoroughly. In order to do this, it is recommended that you allocate an approximate word count to each section of the project. Below is an example you could use:
Section of the report
|
Approximate word count
|
Executive summary
|
500
|
Section 1. Introduction
|
300
|
Section 2. Challenges / problems the client is facing
|
500
|
Section 3. Purpose of the report
|
100
|
Section 4. Impact of research on stakeholders
|
600
|
Section 5. Evaluation and analysis of secondary data
|
2000
|
Section 6. Recommendations and conclusion
|
1000
|
Total
|
5000
|
Please note that the above word count is an approximation and should only be used as a rough guide.
Breakdown of Marks
This business project will be marked out of a total of 100.
The table below shows the mark breakdown for each section. Each section is assessed based on the Marking Criteria which can be found at the end of this assessment brief.
Section of the report
|
Breakdown of marks
|
Executive summary
|
10
|
Section 1. Introduction
|
5
|
Section 2. Challenges / problems the client is facing
|
10
|
Section 3. Purpose of the report
|
10
|
Section 4. Impact of research on stakeholders
|
15
|
Section 5. Evaluation and analysis of secondary data
|
30
|
Section 6. Recommendations and conclusion
|
15
|
Presentation, grammar and punctuation, referencing style and
reading
|
5
|
Total
|
100
|
Guidelines
Executive Summary
You are expected to write one page (approximately 500 words) of an executive summary. The executive summary is not to introduce your report but should be a summary of the whole report. You will therefore need to write this after you complete your report.
It should include what your identified issues were, and what your purpose of the report was. You are required to discuss how your report would impact on main stakeholders. You should also summarise your critical evaluation results.
Your executive summary should be concluded by any recommendations, making up the final part of your executive summary.
Your readers should be able to understand the focus of your project just by reading the executive summary.
Introduction
You could write this section with three different areas. The first area can be used to explain the context of your consultancy report.
The second part could be used to briefly discuss the current issues in your selected company. This area will be the summary of next section but you need to set the scene here.
The final part of this section will need to include how the report will be structured, and what your readers can expect to take from your report.
Challenge / problems the client is facing
You could discuss existing or potential future issues caused by current affairs.
If you decide to discuss current / existing issue(s), you would need to evaluate why your chosen company [client company] has been facing these issues and connect these issues to current affairs.
If you would like to discuss possible future issues which might occur because of the current affairs, you would need to discuss, as consultant’ perspective, why your client company might face challenges in future because of current affairs.
Purpose of the report
You would need to state the purpose of the report. You could explain why you are evaluating specific issues and how this would benefit your client company. Your purpose of the report should be justified by the identified issues established in the section 2. Your purpose of the report will form the question you later evaluate and suggest recommendations for.
Impact of Research on Stakeholders
In this section, you will firstly need to identify who your internal and external stakeholders are in relation to your report. You will also need to discuss how your project is connected to different groups of internal and external stakeholders, and finally evaluate how your project would impact these stakeholders.
Evaluation and analysis with secondary data for your purpose of the report
This section is to show your critical evaluation skills.
You would need to collect secondary data and analyse the data to answer your purpose of the report. You could include tables or charts using existing data you have collected if you wish to. You should ensure that sources of data are referenced correctly.
For the critical evaluation, you may be able to use theoretical frameworks or evaluate data you collected without specific frameworks. However, you need to remember that you would need to compare and contrast different data and discuss how different data shows different perspective for your purpose of the report.
Recommendations and Conclusions
Your recommendations should be justified by the results of your analysis and critical evaluation, and you must also ensure that these recommendations are connected to your purpose of the report. It may be helpful for your readers if you remind them in this section what your purpose of the report was, and how this has been answered by your recommendations.
For the conclusion, you will need to address the key issues you have evaluated and how you have answered the purpose of your report. You should use evidence from the previous sections to support your conclusion.
Presentation
You should use the Harvard referencing system throughout the report and make sure there are no errors in spelling or grammar. You will need to use academic writing and your language should be clear and precise.
Your report must use a consistent approach to headings, tables and graphs. Pages should be clearly numbered, and this should correspond to the page numbers provided in the table of contents.
You will need to show a broad range of reading including academic journal articles.
100% Plagiarism Free & Custom Written, Tailored to your instructions